From:
Don Dougan <dondougan@zzzzzzzz>
Date:
Tue, 24 Feb 2004 23:15:46 -0500
Subject:
Natural faults (cyanoacrylate glue)
Helen:
Quoted text begins.RE: ". . . natural fault or fissure containing crumbly material . . .
cyanoacrylate glue"
End of quote.
II have used it and it will work -- there has been no discoloration with
time (over six or seven years in my experience). Sometimes you will need
to apply it prior to working the stone with tools, then re-apply it as
you wear away the surface (it does only penetrate a limited depth) as
needed for each carving or sanding grit operation. Usually the last
application will be done prior to about 220-grit, and will probably
penetrate to a depth that is retained after finishing up to the 1200-grit
stage.
I use it primarily on flaws in marble, but have used it for alabaster,
soapstone, serpentine and granite as well. It polishes up much the same
as the surrounding stone -- an un-noticeable repair to the average viewer
as long as you allow it several hours to completely harden before
re-working the affected area.
Good sanding to you,
Don
http://www.dondougan.com
- Previous by Thread: message 00222: Blue stones - Ken Barnes (25 Feb 2004)
- Next by Thread: message 00237: diamond chainsaws - Doug Kimble (26 Feb 2004)
- Previous by Date: message 00224: Yule marble shear strength through "bedding Plane" - Stacy Shure (25 Feb 2004)
- Next by Date: message 00226: carving ethics - Don Dougan (25 Feb 2004)
