From:
"Simon Brown" <moonsong@zzzzzzzzzzzzzzz>
Date:
Sun, 27 Jun 2004 14:42:20 +1000
Subject:
Small Detail Work - Technique Question
Quoted text begins.I need to cut some deep inside right angle corners in tight areas
End of quote.
Dear Wm,
Drilling holes into the corners to establish the depth is a good strategy
(thanks George!), another tool you could try in addition to the skewed
chisel (thanks Don!) is the cranked chisel:
http://www.hilti.com/holcom/modules/prcat/prca_fuse.jsp?RANGE_OID=15340
Simon
- References
- message 00189: Small Detail Work - Technique Question - Wm Pulling (25 Jun 2004)
- Previous by Thread: message 00189: Small Detail Work - Technique Question - Wm Pulling (25 Jun 2004)
- Next by Thread: message 00204: Small Detail Work - Technique Question - Walter S. Arnold (27 Jun 2004)
- Previous by Date: message 00202: drilling - Simon Brown (27 Jun 2004)
- Next by Date: message 00204: Small Detail Work - Technique Question - Walter S. Arnold (27 Jun 2004)
