From:
VenezianoJ@zzzzzzz
Date:
Mon, 28 Jun 2004 13:23:58 -0400
Subject:
Cutting glass blocks
shot in the dark...take a short glass drilling bit, and weld it to a longer shaft....
Hello group-any advice on how to make a 3" long cut (1/4-1/2" thick) on 6x6"
glass blocks? The only glass cutting drill bits I've seen are small-I want
to make a 2-3" diameter hole from both ends of a block so I can pass something
through. Thanks--Ariel
- Previous by Thread: message 00213: protecting fossil limestone outside - John VanCamp (29 Jun 2004)
- Next by Thread: message 00216: lettering chisels - scott vore (29 Jun 2004)
- Previous by Date: message 00207: Cutting glass blocks - ARIELTEITE (28 Jun 2004)
- Next by Date: message 00209: Cutting glass blocks - Simon Brown (28 Jun 2004)
