From:
"John Halter" <halter@zzzzzzzzzz>
Date:
Mon, 19 Sep 2005 18:37:06 -0700
Subject:
Hammer for pitching
Hello Daed,
Thank you and Irwin Stone for the response. The stone I am working is 37"h
x 22"w x 15"d. I am just trying to knock off the corners. My final figure
is 34"h x 16"w x 11"d. So I need to knock off 2-3 inches of each edge.
If tracing means creating a cut line on the surface for the handset to
follow - then I am doing that. I am basically following the technique on
the Trow & Holden video. I gather from your comments that 2" might be too
much to try and pitch. It appears from the T&H video he takes off even
more?
I am going to order a 3lb hammer and try to pitch less going forward. If
that fails I can always go back to my diamond blade.
Regards,
John Halter
halter@----------
- Follow-ups
- message 00705: Hammer for pitching - George Graham (21 Sep 2005)
- message 00704: Hammer for pitching - daedelus lanthanien (20 Sep 2005)
- References
- message 00702: Hammer for pitching - daedelus lanthanien (19 Sep 2005)
- Previous by Thread: message 00702: Hammer for pitching - daedelus lanthanien (19 Sep 2005)
- Next by Thread: message 00704: Hammer for pitching - daedelus lanthanien (20 Sep 2005)
- Previous by Date: message 00702: Hammer for pitching - daedelus lanthanien (19 Sep 2005)
- Next by Date: message 00704: Hammer for pitching - daedelus lanthanien (20 Sep 2005)
