From:
"Irwin Stone" <irwinstone@zzzzzzzzz>
Date:
Mon, 7 Nov 2005 08:36:44 -0500
Subject:
core drill bit
Is the butt end seated fully against a flat machined hub on the grinder? I
always have a machined spacer about 1/4" thick on the drill/grinder shaft
before mounting a core bit. If the bit's threads are bottoming out before
the flat end seats against the drive tool, the bit will have a lot of
runout.
David
- Follow-ups
- message 00244: core drill bit - zhivago97 (07 Nov 2005)
- References
- message 00237: core drill bit - Zhivago97 (07 Nov 2005)
- Previous by Thread: message 00238: core drill bit - Simon (07 Nov 2005)
- Next by Thread: message 00244: core drill bit - zhivago97 (07 Nov 2005)
- Previous by Date: message 00240: How to paint letters cut in porous stone? - michiel (07 Nov 2005)
- Next by Date: message 00242: slip form masonry - Norman Watts (07 Nov 2005)
