From:
dan groom <borrowedcarbon@zzzzzzzzz>
Date:
Wed, 15 Mar 2006 22:33:14 -0800 (PST)
Subject:
7" cup wheels
I've used a seven inch pearl turbo for a few years in the counter shop we used them on a 9000 rpm bosch but i don't believe they make them any more.I would like to get a decent 900 rpm grinder and set one them cups up again (they make round edges a breeze). but finding a good heavy duty (not weight) 9k grinder is harder than it seems .. any suggestions?
George Graham <georgergraham@----------- > wrote:
Quoted text begins.Just on thought on using 7" wheels. They work great for horizontal work, but
the weight will wear you out when doing a lot of verticle work.
End of quote.
- References
- message 00568: 7" cup wheels - George Graham (09 Mar 2006)
- Previous by Thread: message 00568: 7" cup wheels - George Graham (09 Mar 2006)
- Next by Thread: message 00569: Air Miser? - abknight (09 Mar 2006)
- Previous by Date: message 00598: Dynabrade air requirements - Irwin Stone (14 Mar 2006)
- Next by Date: message 00600: Tanya Preminger - Norman Watts (17 Mar 2006)
