From:
Ken Barnes <barnestrav@zzzzzzzzz>
Date:
Sun, 1 Oct 2006 07:20:52 -0700 (PDT)
Subject:
epoxy problem
Hi all, attempted to epoxy a pin into a hole this week, and the epoxy
never set. I used the hardener on a different epoxy mix the week
before,so I am assuming this flowing grade of epoxy has gone bad. But
now I havea hole and pin that are all gunked up with flowing epoxy, and
I would liketo clean it out for another attempt. I can easily enough
wipe the pin mostly clean, but am wondering if there are any good ways
to address the hole.I will use rags to get as much as possible, but does
anyone know what chemicals will get me to a clean hole?
- Follow-ups
- message 00578: epoxy problem - George Graham (01 Oct 2006)
- Previous by Thread: message 00570: lichen on stone - Norman Watts (29 Sep 2006)
- Next by Thread: message 00578: epoxy problem - George Graham (01 Oct 2006)
- Previous by Date: message 00576: Cairn - Calvin Babich (30 Sep 2006)
- Next by Date: message 00578: epoxy problem - George Graham (01 Oct 2006)
